GF-Slider
The slider that is also a rig.
Two precision rails and two end mounts in eight lengths from 60 to 300 cm, one carriage that runs on all of them. There is no dedicated top or bottom, and every hole in the rails is a mounting point.
- 01Camera mount
- 02Precision rails
- 03Tracking carriage
- 04End mounts
One carriage. Eight lengths.
Only the rails change. The carriage, the end mounts, the camera mount and the base underneath fit all eight lengths from 60 to 300 cm, and every rail carries its size engraved on the end face.
So you buy the slider once and the lengths as you need them. A complete 120 for the van, a pair of 200s for the days a move needs room — swapping them is four screws and a minute, not a second slider.
The perfect Rigging Slider
Most sliders have a working side. The GF-Slider does not. The rails are drilled with 3/8"-16 threads an inch apart over their full length, and the carriage rides between them without covering a single hole. Lay it flat on the floor, screw it to a tabletop, hang it under a ceiling rig or stand it on levelling legs. The geometry stays the same in every orientation.
The end mounts continue the thread grid and add a rosette interface, so nose mounts, scaffold adapters and levelling legs bolt straight to the slider ends.
Offset without tools.
The base mount does not sit on the rails. It sits on side plates, and those clamp into the slider with hand screws. Loosen two screws, slide the whole base along the rails, tighten again: the balance point moves wherever the shot needs it, on set, without a tool in your hand.
That is what makes an overhanging move possible in the first place — run the rails far out over the support and let the counterweight side do the work.
Sliding offset mode.
Fix the carriage to the support instead of the rails, and the rail bed becomes the moving part: it slides past its own footprint for offset pans, tabletop moves and tracking shots in places where a full slider would not fit.
Build your GF-Slider System
Eight decisions, one slider. Prices update as you choose, and the finished parts list goes into your inquiry with one click.
A case for every length
Sixteen cases: for every rail length there is one for the assembled slider and one for a bare pair of rails.
| Rail length | Packed slider | Rails only |
|---|---|---|
| 60 cm / 2' | €685 | €605 |
| 70 cm / 2'4" | €705 | €620 |
| 100 cm / 3'3" | €825 | €645 |
| 120 cm / 4' | €860 | €670 |
| 160 cm / 5'3" | €1,015 | €705 |
| 200 cm / 6'7" | €1,200 | €730 |
| 250 cm / 8'2" | €1,490 | €870 |
| 300 cm / 9'10" | €1,650 | €940 |
